Rane Performer - System Menu

45
System Menu
The PERFORMER system menu allows you to customize crossfader, microphone,
display, and other device settings. To access the system menu settings, press and
hold Shift and press the HW / SW FX button.
The joystick and the Parameter/FX Select encoder can be used to navigate the
menu.
Push the Parameter/FX Select encoder to confirms value changes.
To exit the system menu settings, use the joystick to navigate back to the root.
Alternatively, press HW / SW FX or one of the 6 FX slot buttons to exit the system
menu.
Menu:
• SILENT CUE: This setting allows you to change the function of the Censor
button to Silent Cue.
o MODE: YES or NO (Default = NO)
• CH FADERS: This setting allows you to change the channel fader response.
o CONTOUR: 0-100% (Default = 50%)
o REVERSE: ON or OFF (Default = OFF)
• CROSSFADER: This setting allows you to change the crossfader cut in amount.
o CUT IN LEFT: 0-10 (Default = 3)
o CUT IN RIGHT: 0-10 (Default = 3)
o RESTORE DEFAULTS: CANCEL or RESTORE (Default = CANCEL)
•
FADER FX
o ON or OFF (Default = ON)
• MAIN METER: This setting allows you to change what signal the meter displays.
o SIGNAL OUTPUT: POST MAIN, PREMAIN (Default = POST MAIN)
• MICROPHONE: This menu option allows you to change microphone echo,
talkover, and microphone signal routing.
o ECHO FDBK: 0-100% (Default = 80%)
o TALKOVER LVL: LOW (-10 dB), MED (-20 dB), HIGH (-40 dB) (Default =
-20 dB)
o TALKOVER HLD: 0.5 - 2.0s (Default = 1.0s)
o TO BOOTH: ON, OFF (Default = OFF)
o TO HEADPHONE: ON, OFF (Default = OFF)
o TO COMPUTER: ON, OFF (Default = ON)
• MOTOR TORQUE: This menu option allows you to adjust the platter’s motor
setting.
o TORQUE: HIGH, LOW (Default = HIGH)