Rane Performer - Pitch Play; Saved Loops

28
Pitch Play
To enter Pitch Play mode, quickly double tap this button. In this mode, the
performance pads oer a range of dierent keys for the active hot cue (adjustable
by semitones). The Serato Pitch N Time plugin must be installed to use this mode.
See H
ot Cue to learn how to assign hot cue points.
T
o enter Pitch Play mode, quickly double tap Hot Cue pad mode button.
T
o select which hot cue point to use, press and hold Shift and press a dimly lit
P
ad.
T
o select the range of transpositions the pads will use, press the Parameter </>
buttons.
T
o play the track from the hot cue point, press a lit Pad. Each pad corresponds to
a specific transposition (by semitones), depending on the current range of
transposition.
A pad with no semitone selected will be lit dim. A pad with a semitone selected will
be lit at full brightness. A pad with no transposition (the original pitch) will be lit
white.
Saved Loops
In Saved Loops mode, each pad triggers a loop previously saved in your software.
T
o enter Saved Loops mode, quickly double tap Roll pad mode button. The pad
LED will be o when no loop is saved to a pad. The LED will be bright green when a
loop is saved to a pad. The LED will be bright blue when a saved loop is active.
T
o play a loop, press a lit Pad. Each deck’s eight pads will correspond to Saved
Loops 1–8 in your software.
T
o activate the saved loop, press the pad to activate the loop or press and hold
S
hift and press the corresponding pad to activate and jump to the loop position in
the track.
T
o halve the loop size, press the Parameter < button.
T
o double the loop size, press the Parameter > button.
T
o move the active loop region backward at the current loop size without
d
eactivating the loop, press and hold Shift and then press the Parameter < button.
T
o move the active loop region forward at the current loop size without
d
eactivating the loop, press and hold Shift and then press the Parameter > button.