Rane Performer - Pad Modes; Hot Cue

26
Pad Modes
This chapter describes the dierent pad
modes. Each deck has eight pads, which are
always in one of these modes, and each
deck’s pads can be in a dierent mode. Press
one of the P
ad Mode buttons to enter the
corresponding pad mode on that deck. The
pads will remain dim when unselected, at full
brightness when a pad mode is selected, and
flashing between dim and full brightness
when a secondary pad mode is selected.
Hot Cue
In Hot Cue mode, each pad assigns a hot cue point in the software or returns the
track to that hot cue point. The performance pad LEDs will remain unlit until a hot
cue is placed or will light if the loaded track already has Hot Cue points assigned.
T
o enter Hot Cue mode, press Hot Cue.
T
o assign a hot cue point, press an unlit Pad at the desired point in your track. The
pad will light up when it is assigned (with the corresponding color, if available).
T
o jump to a hot cue point, press a lit Pad.
T
o delete an assigned hot cue point, press and hold Shift and then press the
corresponding pad.
T
o arm FLIP recording, press Parameter <. The Censor or Hot Cue action initiates
recording when FLIP mode is record armed. Press P
arameter < again to disarm FLIP
recording.
T
o stop recording and turn FLIP on / loop FLIP, press Parameter >.
Note: FLIP Expansion is required for this function.
5
6
1 2
7
8
3
4