Rauch AXIS-M 30.2 - Page 113

Faults and possible causes
105
9
Irregular fertiliser feed to
spreading disc
Fertiliser bridging above the
agitator
 Remove fertiliser until the
height of the protective grid
on the affected side.
 Break up accumulated fer-
tiliser with a wooden stick
through the bars of the pro-
tective grid.
Outlet blocked
 See blockages of the mete-
ring openings
Defective agitator
 Remove fertiliser until the
height of the protective grid
on the affected side.
 Open the metering slide
and break up accumulated
fertiliser with a wooden
stick through the bars of
the protective grid so that
the remaining fertiliser can
run out of the outlet.
 Check the functionality of
the agitator drive. See
chapter 10.8: Checking the
agitator drive, page 119.
Spreading discs are fluttering.
 Check cap nuts for tight fit
and check threads.
Metering slide does not open
 Metering slides do not
move easily.
 Check for smooth mo-
vement of the slide, the le-
ver and the joints, and
improve if necessary.
 Check the extension
spring.
 The reducing plate at the
hose connection of the
plug-in connector is conta-
minated.
 Clean the reducing plate at
the hose connection of the
plug-in connector.
The metering slide opens too
slowly.
 Clean the restrictor plate.
 Replace the 0.7mm restric-
tor plate with a 1.0mm res-
trictor plate. The plate is
located at the hose
connection of the plug-in
connector.
Agitator not working. The agitator drive is defective.
 Check the agitator drive.
See 10.8: Checking the
agitator drive, page 119
Fault Possible cause Measure