Rauch MDS 8.2 - Row Spreading Device RV 2 M1 (Optional Equipment); Machine Pre-Settings

Important information on spreading
101
10
10.7 Row spreading device RV 2M1 (optional equipment)
The row spreading device RV 2M1 is attached in the upper lug of the drawbar.
The row spreading device is designed in such a way that a row [X] on both the
right and left of the machine (row distance: approx. 2-5 m) is spread with fertiliser
in a 1-metre wide planting row [Y].
Figure 10.5: Spreading with the row spreading device
[X] Row distance
[Y] Width of the planting row
10.7.1 Machine pre-settings
Before installing the RV 2M1, the spreading vanes on both spreading discs must
be set to the position A2-A2.
X
Y
n CAUTION
Material damage to spreading vanes and row spreading de-
vice RV 2M1
If the spreading vanes are set to a value higher than A2-A2, the
spreading vanes can hit the guide plates on the row spreading
device RV 2M1.
 Never set the spreading vanes to a value higher than
A2-A2.
 After assembling the row spreading device RV 2M1, check
the free passage of the spreading discs when the tractor is
at a stand-still (turn the spreading discs by hand).