Rauch MDS 8.2 - Fertiliser Spreading Process

Important information on spreading
93
10
10.3 Fertiliser spreading process
The intended use of the machine includes compliance with the operating, main-
tenance, and service conditions in accordance with the manufacturer specifica-
tions. Spreading operation therefore always includes preparation and
cleaning/maintenance.
 Carry out spreading operations in accordance with the sequence described
below.
Preparation
 Attach the spreader to the tractor Page 43
 Close the metering slide
 Pre-set the mounting height Page 47
 Fill with fertiliser Page 56
 Implement the calibration test Page 81
 Set spreading vane Page 68
 Set the application rate Page 60
Spreading
 Travel to the spreading location
 Check the mounting height
 Engage the PTO shaft
 Open the slide and start spreading
 Finish spreading and close the slide
 Disengage the PTO shaft
 Discharge residual material Page 89
Cleaning/maintenance
 Open metering slider
 Remove the spreader from the tractor
 Cleaning and maintenance Page 109