Maintenance and service
119
12
12. Remove the bolt from the metering opening.
13. Loosen the screws [1] of the application rate scale.
9.
Pull out the hydraulic cylinder
Figure 12.8: Pull out the hydraulic cylinder
A second person is required
for this stage.
10. Person 1: Insert the lower
link pin into the metering
opening (see stage [9]
).
Person 2: Move the position
pointer to smaller values un-
til the metering slide is at the
bolt [1].
Figure 12.9: Move the position pointer
11. Move the stopper to the po-
sition pointer and clamp the
stopper tightly.
Figure 12.10: Move the stopper
To Next Page
Loading...
