Commissioning
41
7
6. Grease the transmission
spigot. Push the universal
drive shaft onto the trans-
mission spigot.
Figure 7.2: Push the universal drive shaft
onto the transmission spigot
7. Tighten the hex cap screw
and nut using a size 17
wrench (max. 35 Nm).
Figure 7.3: Connect the universal drive
shaft
8. Push the universal drive
shaft guard with hose clamp
over the universal drive
shaft and attach it to the
transmission neck.
9. Tighten the hose clamp.
Figure 7.4: Mount the universal drive shaft
guard
To Next Page
Loading...
