Commissioning
51
7
Setting the mounting height during late fertilising
Requirements:
The machine is installed at the highest connecting point of the upper link at
the tractor.
The lower link of the tractor is installed at the upper coupling point of the
lower link of the machine.
Proceed as follows when determining the mounting height (in late fertilising
mode):
1. Determine the mounting heights A and B (above crop height) from the fertil-
iser chart.
2. Compare the mounting heights A and B plus the crop height with the maxi-
mum admissible mounting heights at the front (V) and rear (H).
Figure 7.10: Mounting position and height during late fertilising
The following applies:
A + crop height ≤ V Max. 770 mm
B + crop height ≤ H Max. 830 mm
To Next Page
Loading...
