Ravas RCS - 10.4 Indicator Information; Display Indications Overview; Indicator Error Messages

USER MANUAL – RCS
39
NET
kg/lb
10.4 The indicator
Display indications
By means of three pointer bars the display of the indicator shows:
◄ The load measurement system (including load) is stable.
▬ The weight shown is negative.
NET ◄ The display shows the net weight.
The following indications can be shown in the display:
HELP 1 The load measurement system has been overloaded.
HELP 2 The zero point is below the originally calibrated zero point. See load measurement
system calibration.
HELP 3 Negative signal from the sensor.
HELP 4 The tare value entered (manually) is too high. Press key PT again to delete
this help message and key in a lower tare value.
HELP 7
Signal from the sensor is too high.
LO-BA
The batteries are (almost) empty.