28
Figure 11Theclientware interface
4.7.1 The control interface
The control interface is the content displayed on the first page after opening the clientware,
including the user's most commonly used status signal, laser parameter setting and laser control
related functions.
Control abnormal laser reset: Click the reset button to run the abnormal laser reset
command.
Guide laser: the guide laser is turned on or off in the internal control state of guide laser.
After the guide laser is turned on or off, there will be changes in the guide laser state on the
software.
Guide laser external control: turn on the guide laser external control or turn off the guide
laser external control. After turning on and turn off the guide laser external control, there will be
changes of the guide laser external control state in the software.If the current red external control
state, then disable the red control button.
To Next Page
Loading...
Need help?
General
