Raycus RFL-C4000S - Page 36

36
Ethernet
INTERLOCK
AC input
Rear
panel
of
laser
PC
COM
Shorten（pin
1-4,2-3）
The Control
card
Ethernet cable
Pin 15,16（MOD）
Power cord
AC
supply
source
L
PE
L
L
Pin 12,14（0-10V
analog）
Figure 3The power and laser are externally controlled wiring diagram in REM mode
Operation method:
➢ Spring the “ESTOP” knob on the front panel;
➢ Key turning “ON”;
➢ Shortconnect the 8 and 9 pins on the INTERFACE 24 pins (the control board is powered
on);
➢ Open the laser clientware;
➢ Click “the guide laser ON” button to view the guide laser;
➢ Open the AD mode, turn off the external enable, and opening the internal modulation
mode or external modulation mode;
➢ Click ON “the main power ON”;
➢ Waiting “Ready”;
➢ On modulate mode set the frequency, duty cycle, and pulse width;(The laser is determined
by the 15.16 pin modulation signal and frequency and duty cycle);
➢ Modulation signal (15, and 16-pin) and analog quantities (12 and 14 pins) turn on the
laser.
4.9.4 Modulation signal requirements