Chapter 6: Sonar Mode Operation 6-13
Placing a Waypoint
➤ To access the place waypoint soft keys, press MARKS:
➤ To place a waypoint at the cursor position or at the vessel position:
1. Press either the PLACE WPT AT CURSOR or the PLACE WPT AT VES-
SEL soft key. The waypoint is added to the waypoint list and
tagged using the next available number.
The waypoint soft keys are displayed until you move the cursor
away from the waypoint or press CLEAR.
You can use the EDIT WAYPOINT soft key to name the waypoint as
described in Editing Waypoints below.
2. Press CLEAR or ENTER to remove the place waypoint soft keys.
➤ To place a waypoint as latitude/longitude using the Waypoint List:
1. Press MARKS, followed by the WAYPOINT LIST soft key. The Way-
point List and associated soft keys are displayed.
D5572-1
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST
LOAD/SAVE
USER CARD
MARKS
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
D4163-1
GOTO
WAYPOINT
EDIT
WAYPOINT
ERASE
WAYPOINT
MOVE
WAYPOINT
MARKS
WAYPOINT
LIST
To Next Page
Loading...
