3-6 DSM250 Digital Sounder Module
Figure 3-3 demonstrates how to setup the DSM250 for Simulator
mode; Chapter 2 gives full installation details.
Figure 3-3: Simulator Mode Setup
Viewing Simulator Data
After you have properly connected and powered up the DSM250
and display units, you can toggle Simulator mode on and off using
the Sonar Setup menu.
➤ To view simulated sounder images:
1. Press the MENU key on display unit.
The Setup soft keys appear.
2. Press the SONAR SET UP soft key.
The Sonar setup menu pop-up is displayed.
3. Use the trackpad to move the selection bar over the option
SONAR SIMULATOR. The simulator soft keys are displayed.
4. Press the ON soft key to switch on the sonar simulator.
5. Press ENTER twice to return to the default display.
When simulator mode is on a simulator dialog box is displayed.
When the display is switched off then on again, simulator mode is
maintained. It is recommended that you select the System Set Up
Menu and switch off simulator mode when you have finished.
Note: Any waypoints placed on the chartplotter in simulator mode
are retained in the database list and are available for use in routes.
hsb
2
PLUS Display Unit
DC Volts
Red
Black
D6197-1
RF Ground
hsb
2
Digital Sounder Module
MENU
SONAR
SET UP¬
To Next Page
Loading...
