Raymarine G-Series system - 4.4 Monitor connections

G-Series Installation & Commissioning 38
4.4 Monitor connections
Connect the G-Series marine displays to both the GPM400 proces-
sor and SeaTalk
hs
switch.
Monitors may be connected to the GPM400 using either VGA or
DVI cable.
Repeat displays
Repeat displays (if used) show the same information / page as the
master display. For this reason each display within a Nav Station
must be connected to a different GPM400.
Note: During start-up only the master display will show the boot
sequence and start-up information.
Maximum quantity of monitors
The G-Series system will support up to 8 monitors (2 per GPM400).
CameraCamera
Monitor
GPM 400
Repeat Monitor (optional)
DVI or VGA
DVI or VGA
SeaTalk
hs
SeaTalk
hs
SeaTalk
hs
D10074-1
SeaTalk
hs
switch
Composite video Composite video
D10075-1
Power Cable
DVI
Input
SeaTalk
hs
SeaTalk
hs
VGA
Input
VGA
input
adaptor
cable
DVI
Input
VGA
Input
Network selector switch
(in UP position)
Monitor
HS switch
GPM 400
OR