79 Chapter 7: Initial Setup
fer these with the Serial numbers on your Nav Station
schematic diagrams.
• Assigned to
Shows the assignment of the selected keyboard.
To assign a Keyboard to a Nav Station
from the Assign Keyboards menu:
1. Select the desired keyboard from those displayed.
2. Press ASSIGN TO NAV STN.
Then either:
i. Select from the list of available Nav Stations. OR
ii. Press the ASSIGN TO ALL NAV STNS softkey.
3. Press OK when complete.
To assign a Keyboard to an individual monitor
from the Assign Keyboards menu:
1. Select the desired keyboard from those displayed.
2. Press ASSIGN TO MONITOR.
3. Select from the list of available Monitors.
4. Press OK when complete
To identify the correct keyboard
If you are unsure of which keyboard to select, press the
IDENTIFY KEYBOARD softkey to show a message on the monitor
to identify the keyboard being used.
To Next Page
Loading...
