6 Pathfinder Smart Heading System - Owner’s Handbook
2 Installation
Tools required
• drill and 3 mm (
1
/
8
in) drill bit
• cross-head/pozi-drive screwdriver
• small flat-bladed screwdriver (for GyroPlus 2 unit terminals)
• wire-strippers
• hand bearing compass (to help identify suitable fluxgate location)
Parts required
Additional parts required
In addition to the parts supplied you may also require:
• suitable 2-core cable for NMEA output to Pathfinder Plus
• suitable power cable and 3 A fuse/circuit breaker (if required)
• additional SeaTalk cables (if required)
Cabling guidelines
When running cables, always observe the following guidelines:
• if a cable has to be fed through the deck, use a good quality deck gland
• where cables are fed through holes, use grommets to prevent chafing
• secure long cable runs so they do not present a hazard
• wherever possible, route cables away from fluorescent lights, engines
and radio transmitting equipment, as these may cause interference
!
COMPASS AREA
No 8 x 1 inch pan-head
self-tapping screws (x6)
Cable ties (x6)
Compass
warning label
Fluxgate compass
with 8 m (26 ft) cable
GyroPlus 2 unit
Smart Heading System - parts supplied
2 m (6 ft 6 in) SeaTalk cable
(plug at one end, bare ends at other end)
D5914-1
Also packed: Owner's Handbook (including warranty information) & Worldwide Distributors List
81198_1.book Page 6 Monday, February 11, 2002 8:36 AM
To Next Page
Loading...
