14 Pathfinder Smart Heading System - Owner’s Handbook
2 Installation
The following diagram shows recommended mounting positions for
steel-hulled boats.
Note: The higher above the waterline you mount the compass, the more
the boat’s pitch and roll will affect compass performance.
Figure 2-3: Compass - recommended location for steel-hulled boats
Mount the fluxgate compass
CAUTION:
You must mount the fluxgate compass vertically, with the cables
exiting at the base.
1. Hold the fluxgate compass against the mounting location.
2. Mark the four mounting holes, then remove the fluxgate compass.
3. Drill four pilot holes using a 3 mm (
1
/
8
in) drill bit.
4. Making sure the cable exits at the bottom, secure the fluxgate
compass using four of the self-tapping screws provided (No 8 x 1 in).
1.8 m (6 ft)
D5383-2
1.2 m (4 ft)
1.2 m (4 ft)
81198_1.book Page 14 Monday, February 11, 2002 8:36 AM
To Next Page
Loading...
