3.4Mounting
T
oolsrequiredforinstallation
1.P owerdrill
2.Jigsawforpanelmountcut-out
3.Pozi-drivescrewdriver
4.Adhesivetape
5.7mm(9/32”)Wrench(spanner)forbracketmounting
fixings
6.Fileforpanelmountcutout
7.Holesawforpanelmounting(Forholesawsizerefer
toyourproduct’smountingtemplate)
8.Drillbitforsurfacemountingorbracketmounting
Mountingoptions
Theproductcanbemountedinthefollowing
configurations.
1.Bracketmount—T abletop
2.Bracketmount—Overhead
3.Bracketmount—Bulkhead
4.Panelmount
Bracketmounting
Followthestepsbelowtomounttheproductonit’s
bracket.
Beforemountingtheunitensurethatyouhave:
•Selectedasuitablelocation,ensuringthereisnothing
behindthemountingsurfacethatmaybedamaged
whendrilling.
•Identifiedthecableconnectionsandroutethatthe
cableswilltake.
•Attachedthefrontbezel.
1.Markthelocationofthebrack
etmountingholeson
themountingsurface.
2.Drillholesforthemountingfixingsusingadrillwith
asuitablesizeddrillbit.
3.Usethefixingsprovidedtoattachthebracket
securelytothemountingsurface.
4.Attachtheunittothebracketandsecureinplace
usingthebracketmountingknobs.
Note:
Drillbit,tapsizeandtighteningtorqueisdependent
onthethicknessandtypeofmaterialtheunitisto
bemountedon.
Installation25
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 25 6/13/2018 2:30:10 PM
To Next Page
Loading...
