thelocationofthescrewholesandthecenterhole
onthemountingpanel.
T
oensurethatthehandset’sconnectorpointsdown
whenconnected,orientatethemountingplateso
thatthelanyardgroveispointingstraightup.
3.Drillthemountingholesusingasuitablesizedrillbit.
4.Drillthecenterholeusinga25mm(1in.)holecutting
saw.
5.Pulltheconnectorendofthecablethroughthehole
inthemountingsurface.
6.PlacetheMountingplategasketovertheendofthe
connector.
7.Withtherecessedsidefacingawayfromthe
mountingpanel,placetheMountingplateoverthe
endoftheconnector.
8.PlacethelanyardendoftheSplash-proofdustcap
overtheconnector,ensuringthelanyardsitsinthe
recessintheMountingplate.
9.PlacetheMountingplatenutovertheconnectorand
tightenclockwiseusinga13/16in.(21mm)socket
wrench,beingcarefulnottodamagetheplasticnut
byovertightening.
10.SecuretheMountingplatetothemountingsurface
usingthesuppliedscrews.
11.AttachtheHandset/Fistmicconnectortothecable
connectorandrotatethelockingcollarclockwiseto
secure.
12.Connecttheoppositeendofthecabletothe
requiredconnectoreitherontheBasestationor
toanotherpass-throughpanelmountingplate
connector.
Note:
Drillbit,tapsizeandtighteningtorqueisdependent
onthethicknessandtypeofmaterialtheunitisto
bemountedon.
Installation29
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 29 6/13/2018 2:30:11 PM
To Next Page
Loading...
