36 S1 Wheel and Tiller Pilots Operating Guide
3.2 Gener al maintenance
Routine checks
CAUTION: Do not dismantle SmartPilot products
The Sm artPilot computer and controller should be serviced only
by aut horized Raymarin e service te chnicians. These products do
not con tain any user serviceable parts.
T he SmartPilot comp uter does NOT co ntain userserviceabl e parts . If you remove
the main c over you wil l inv alidate th e warra nty. T he c ontroller is also a seal ed
unit, so user maintenance is limited to the following checks
• mak e sure all cable connect ors are firmly attached
• examine for signs of wear or damage – replace any damaged cables
Note:
Do not use chemical or abras ive materials to clean the SmartPilot compu ter. If the
case is dirty, wipe it with a clean, damp cloth.
Cleaning the display
CA UT ION: Av oid da mage wh en clean ing
T ake care when cle aning the display. Avoid wiping t he display
scr een with a dr y cloth as this could scratch the screen coating. If
nece ssary , use only a mild detergent.
• Never use chemical or abrasive materials to clean the controller . If it is dirty,
wipe it with a clean , damp cloth.
• In certain conditions, condensation may appear inside the display screen. This
will not harm the unit, and you can clear it by switching on the illumination for
a short tim e.
RG F AIL
GyroPlu s yaw sensor has failed:
• If you have a S1G , S2G or S3G course computer with internal
GyroPl us sen sor – call a Ray marin e serv ice agent.
• If you have a NonG
s
course comp uter with external GyroPlus
yaw sensor – check the sensor and connections, then call a Ray
marine s ervice agent.
SEATALK
and
FAIL 1
or
2
SeaT alk data p roblem o n one o f t he SeaT alk lines – check con nec
tions.
SEATALK
and
FAIL
The contr ol unit cannot tr ansmit data to th e SeaT alk system. Make
sure all SeaT alk cables are connected properly.
ALAR M MESSAGE POSSIBLE CAUSE and SOLUTION
81283_1.book Page 36 Monday, October 2, 2006 2:03 PM
To Next Page
Loading...
