F.4 Raytech USB Driver
If you would like to send commands to the CAPO over the USB-port, you have to activate the
Raytech USB driver.
Use the Service Code '2001#' to do so, but
normally it's already done
F.5 Show Series Values
With the service code “125#”, the CAPO shows the series values additionally of the equivalent
circuits:
Activate this function with the Service Code
125#, the following window will show, tap
Yes
In the main screen, a new Values will
appear over your measurement data
Have a look at chapter “6.2.2 Equivalent circuits” on page 27 for background information.
The Service Code is not persistent, you have to re-enter the code after restarting the CAPO.
To Next Page
Loading...