Raytech CAPO 2.5 - Start a Measurement

Preliminary
Under the tab Sweep it would be possible to store different lists of voltages.
The CAPO will start with the first voltage of the selected list. After a proper result, it will
automatically change to the next voltage and perform the measurement.
Edit a list:
To Add or Remove a voltage of the list, use
the button + or -
8.2.6 Start a measurement
Before performing any test with this instrument, read this user manual and observe all safety
precautions indicated.
There are different measurement modes: Single, Continuous, Multi.
90315-1.2 Instruction Manual CAPO
Page 53 of 117
WARNING !
WARNING !
Hazardous voltage may result in severe injury or death!
NOTE:
NOTE:
The FIRST cable you have to connect and lead to earth ground, is always
the Safety GND