Raytech CAPO 2.5 - Oil Correction Table

Preliminary
8.2.7.3 Oil Correction Table
1
After you enter the Service Code #1200 a
new symbol in the upper menu will appear.
It is possible to make a measurement
correction of the PF or tan δ on the basis of
the temperature.
Normally this feature is disabled. But if you need it, read chapter F.6 “Oil Correction Table“ in the
appendix on page 107.
To enter a Service-Code, check chapter F in the appendix “Service Mode“ on page 104.
1 This is only available if you entered the Service Code “1200#”
90315-1.2 Instruction Manual CAPO
Page 62 of 117
NOTE:
NOTE:
To access this feature, you must enter the service code "1200#" first