8.2.7.1.7 Service
There are several embedded codes to allow different settings, e.g. calibrate the touchscreen,
activate USB-driver and so on. For more information see chapter F Service Mode on page 104.
The Service Mode has a limited access.
Enter the corresponding code or exit
directly by tapping '#'
8.2.7.2 Operator
Every measurement can be stored with the name of the actual operator. In this menu,
new operators can enter their first and last name. Existing entries can be changed.
Touch an operators name and then touch
OK to make your choice.
Note the " ü Ask for Operator at Power-up”, when checked, you will be asked if the chosen
operators name is yours during the start up of the instrument. This may be helpful, when several
operators are using the same CAPO.
To Next Page
Loading...