23
Smart Vent Control Screen
The Smart Vent control screen shows the current Smart Vent information and allows you to select
operating modes and other functions. The screen information and controls are shown below.
INSIDE Temp: Current inside temperature display
OUTSIDE Temp: Current outside temperature display
SETPOINT: Vent Setpoint (indoor temperature at which venting stops)
MODE Button: Selects the vent operating mode. Off, Auto or Manual
Off Mode: no automatic vent operation
Auto Mode: Will automatically vent if outside temperature is cooler than inside temperature and
inside temperature is above the vent setpoint.
Manual Mode: Turns on venting system. Stays on until set to Off mode.
TIMED VENT Button: This is a one button “quick vent” mode of operation. Pressing the Timed Vent
button will turn on the venting system, run for 30 minutes and then turn off. Pressing the button again will
add 30 minutes to the vent run time, up to 2 hours. Pressing one more time will turn the timed vent off.
Timed Vent time remaining is displayed in the upper right hand corner of the display.
SETUP Button: Takes you to the Smart Vent Setup screen. The Smart Vent can be set to run on a daily
schedule of run cycles. The Smart Vent Setup screen allows you to select the Schedule ON/OFF mode
and set the daily run time Schedules.
Timed Vent
Time remaining indicator
To Next Page
Loading...
Need help?
General
