WorkHorse Sentinel User's Guide
P/N 957-6163-00 (January 2001) page 27
11.3 Use the Deployment Wizard
10 MB
RECORDER
(INSTALLED)
Figure 11. Using the Deployment Wizard
There are five steps the Deployment Wizard helps lead you through; Plan-
ning, Setting the ADCP’s clock, Compass Verification, Pre-Deployment
Tests, and sending/verifying the commands to the ADCP. RDI highly rec-
ommends using the wizard each time you deploy the ADCP. The deploy-
ment wizard will start whenever a new deployment file is created. To use
the deployment wizard, do the following.
a. Connect and power up the WorkHorse.
b. Start WinSC.
c. Start the Deployment Wizard by doing one of the following.
• At the Welcome screen, click Configure an ADCP for a
New Deployment. Click OK.
• Click File, New Deployment (the deployment wizard will
start automatically).
• If you are working on an open deployment file (*.dpl), on the
Functions menu, click Deployment Wizard.
NOTE. Choose and use Deployment Names carefully: they help you
identify and organize all the data and log files associated with each
deployment.
To Next Page
Loading...