Electromagnetic Compatibility (EMC)
This product complies with Council Directive 89/336/EEC when
installed and used in accordance with the relevant instructions.
IMPORTANT, READ THIS BEFORE USING THE APOLLO
The Apollo installation is a part of the Precision Farming System
("the System"). It is very important that you follow the described
calibration procedures before operating the Apollo instrument.
Calibration and operation of the Apollo must be in accordance with
these instructions. Use of the System is subject to the following
disclaimer;
1. So far as is legally permissible RDS Technology ("RDS"), or its
distributors, shall not be liable, whatever the cause, for any
increased costs, loss of profits, business, contracts, income, or
anticipate savings or for any special, indirect or inconsequential
damage whatsover (death or personal injury excluded).
2. The capabilities and functions of the Precision Farming System
("the System") are limited as set out in the specification of the
System, details of which are contained in the Help files and
product literature and which must be read before using the
System.
3. Without prejudice to the generality of the above it is hereby
acknowledged that the System is not designed nor intended to a)
originate variable treatment plans or b) achieve or avoid any
application rate outside application parameters, which in both
cases shall be the responsibility of the operator.
4. The standard terms and conditions of RDS (except clause 7), a
copy of which is available on request, apply to the supply and
operation of this System.
Service and Technical Support
PLEASE CONTACT YOUR NEAREST DISTRIBUTOR
If unknown then fax: 44 (0) 1453 733311 for further information.
Our policy is one of continuous improvement and the information in
this document is subject to change without notice.
Check that the software reference matches that displayed by the
instrument.
© Copyright RDS Technology Ltd 2001
\UK221-4b.DTP
To Next Page
Loading...
Need help?
General
