Reach PoE5 Tester Manual 1.8 03/25/2021 Page 20
BAUD
Description: Used to change the unit's baud rate. This will not take effect until the unit
power is cycled or the *boot command is issued. This is done to make
sure the baud change is acceptable.
See EEPROM Warning.
Command: *baud <baudrate>
<baudrate> = 9600, 19200, 38400, 57600, or 115200
Example: *baud 19200
Response: "Console baud set to 19200. Cycle power or issue
*boot to effect change."
BOOT
Description Resets the system to the power-on state. This is the same as if the unit
has its power cycled.
Command *boot
HOSTNAME
Description: Used to change the unit's prompt. This is useful in a production system
because it allows the user to know with which physical unit it is
communicating. Name must be equal or less than 31 characters long.
See EEPROM Warning.
Command: *host[name] <string>
Example: *hostname myTester
This makes the unit's prompt "myTester>"
To Next Page
Loading...