Reach RT-PoE5 - Appendix B - Test Setups; Overview; Signature Detect

Reach PoE5 Tester Manual 1.8 03/25/2021 Page 36
Appendix B - Test Setups
B.1 Overview
This Appendix gives an overview of basic test setups. No port or group prefixes are
shown. PSE, PD as defined in IEEE 802.3bt. The RT-PoE5 commands are issued in the
order shown.
B.2 Signature Detect
RT-PoE commands:
PSE check after commands issued
reset
detect ok
mps on
connect on
Verify that the PSE recognizes a valid PD.
connect off
detect lo
connect on
Verify that the PSE detects a low signature
resistance.
connect off
detect ok
connect on
Verify that the PSE recognizes a valid PD.
connect off
cap on
connect on
Verify that the PSE detects a bad capacitance.