Reach RT-PoE5 - Show All; Clear; Load

Reach PoE5 Tester Manual 1.8 03/25/2021 Page 21
SHOW ALL
Description Shows the current (last-sent) state of all commands on each port. Note
that there is no ‘port’ or ‘group’ syntax for ‘show all’.
Command: sh[ow] all
Response: [See example below]
Example: show all
Example response: (table truncated for brevity)
class
det
cap
conn
set
pwr
ext
short
single
mps
inrush
p1:
3L,3L
OK,OK
0,0
0,0
1000,1000
-SET-
1
0,0
0
0,0
85
…
…
…
…
…
…
…
…
…
…
…
P8:
4D,4D
LO,LO
0,0
1,1
---PWR---
50,50
1
0,0
0
1,1
85
CLEAR
Description Clear user settings in EEPROM. Note that there is no ‘port’ or ‘group’
syntax for ‘*clear’.
See EEPROM Warning.
Command: *clear
Response: EEPROM clearing settings copy 1
EEPROM clearing settings copy 1
EEPROM settings cleared
LOAD
Description Load user settings from EEPROM. Note that there is no ‘port’ or ‘group’
syntax for ‘*load’.
Command: *load
Response: EEPROM restoring user settings
:p1 restored
:p2 restored
…
:p24 restored