red lion IMP - FACTORY CONFIGURATION

FACTORY CONFIGURATION
The following chart lists the programming of the unit when shipped from the
factory. (Code 66 will restore the unit to these values.)
“Pro 2”..... “dECPNt” - 0.00
“round” - 0.01
“dSP 1” - 0.00
“INP 1” - 4.000
“dSP 2” - 100.00
“INP 2” - 20.000
“SEGt” - 1
“Pro 3”..... “dSP AL” - yES
“ENt AL” - yES
“dSPHYS” - yES
“ENtHYS” - yES
“rStAL” - yES
“dSPbUF” - yES
“rStbUF” - yES
“SELdSP” - yES
“rSttOt” - yES
“tArE” - yES
“Pro 4”..... “FILtEr” - 1
“E1-CON” - 4 (display hold)
“E2-CON” - 4 (display hold)
“Pro 5”..... “dECPNt” - 0
“tbASE” - 0
“SCLFAC” - 1.000
“Lo-cut” - 0.00
“Pro 6”..... “trAc” - NO
“dISP” - NO
“LAtC-1” - NO
“ASN-1” - INPUt
“AL-1” - 0.00
“HYS-1” - 0.01
“Act-1” - HI
“LAtC-2” - NO
“ASN -2” - INPUt
“AL-2” - 0.00
“HYS-2” - 0.01
“Act-2” - HI
“Pro 7”..... “bAud” - 1200
“AddrES” - 0
“Print” - 0
“FULL” - yES
“Pro 8”..... “ASIN” - input
“AN-Lo” - 0.00
“AN-HI” - 100.00
-21-