TABLE OF CONTENTS
I. SAFETY INFORMATION ...................................................................1
II. GENERAL DESCRIPTION ...............................................................2-3
A) Theory of Operation ......................................................................2
B) Block Diagram ..........................................................................3
III. PROGRAMMING AND OPERATING THE IMP ..........................................4-23
A) Programming the IMP ..................................................................4-5
B) Program Modules #1 thru #9 ............................................................6-19
C) Operating the IMP (Quick Programming) ...................................................20
D) Factory Configuration ...................................................................21
E) Programming Example ...................................................................22
F) Pressure Monitoring Example .............................................................23
IV. EXCITATION (Optional) .................................................................24
V. TOTALIZER/LINEARIZER/PEAK/VALLEY/TARE (Optional) ............................24-28
A) Totalizer Example ......................................................................24
B) Linearizer Example .....................................................................25
C) Peak/Valley/Tare .......................................................................27
VI. ALARMS (Optional) ......................................................................28
VII. 20 mA CURRENT LOOP SERIAL COMMUNICATIONS (Optional) .......................29-34
A) General Description .....................................................................29
B) Communication Format ..................................................................29
C) Sending Commands to the IMP .........................................................30-31
D) Receiving Data from the IMP .............................................................32
E) Current Loop Installation .................................................................34
F) Serial Terminal Descriptions ..............................................................34
G) Serial Communication Examples .......................................................34-35
VIII. RE-TRANSMITTED ANALOG OUTPUT (Optional) ....................................36-37
IX. APPENDIX “A” - INSTALLATION AND CONNECTIONS ..............................38-41
X. APPENDIX “B” - SPECIFICATIONS AND DIMENSIONS ..............................42-44
XI. APPENDIX “C” - LINEARIZER PROGRAM ..........................................45-46
XII. APPENDIX “D” - TROUBLESHOOTING GUIDE .........................................47
XIII. APPENDIX “E” - PROGRAMMABLE FUNCTIONS ....................................48-49
XIV. APPENDIX “F” - USERS PROGRAMMING VALUES CHART ..........................50-51
XV. APPENDIX “G” - ORDERING INFORMATION ..........................................52
-i-
To Next Page
Loading...
Need help?
General
