Redarc TVMS Rogue - Output Wiring

Installation — Wiring | 19
OUTPUT WIRING (C/D)
Connecting the TVMSRogue outputs to 12V loads�
The TVMSRogue outputs can be used for switching a wide variety of devices/loads, then allowing
you to monitor and configure them via the RedVision
®
Display or App. Typical loads include:
 Fridge
 Lighting
 Water Pumps
 Fans
 Television
 Stereo
 Accessories — e.g. charging sockets
 Relays — to support switching/control of loads greater than the 10 A limitation of the
TVMSRogue (REDARC RK1260 recommended)
 REDARC Inverters — switching only; not to be used for powering an inverter.
SELECTING LIGHTS:
 LED Light — if you intend to use the dimming capability, check before installing that your
chosen LED lighting is dimmer-compatible. Using non-dimmable LEDs can result in flickering
and damage to the LED light.
 Filament/Incandescent Lights — these are compatible with the TVMS Rogue and are
dimmable, however they are not recommended due to their high power consumption. Opt for
power efficient lights such as LEDs wherever possible.
 Compact Fluorescent Lights (CFL) — most CFL lights are not dimmable, and dimmable
versions are not readily available. These are not recommended for dimming applications.