Redback Technologies
Owner’s Guide – Redback Smart Hybrid System - v 3.8
19
9.5 EMS restart
Occasionally, it may be necessary to restart the EMS software. A restart will reboot the EMS, without needing to restart the
whole inverter, noting that the backup circuit will be briefly interrupted.
DO NOT restart unless instructed to do so by Redback support staff.
Open the BoS switchgear hatch.
Identify the three-position Bypass switch. Note the position of the
switch.
☐ Up ☐ Down
Note: The switch is usually returned to the original position during
Set the Bypass switch to the middle position (OFF).
Wait 5 seconds.
Return the Bypass switch to its original position (if noted)
otherwise place in the DOWN position. The EMS will restart in
approximately 10 minutes, indicated by the EMS LEDs stabilising
Blue; ON (if batteries are connected)
Blue; ON (if Network is OK)
Blue; FLASHING (for extra 30 minutes, then
OFF)
To Next Page
Loading...
