Redback SH5000 - Important safety instructions

Introduction
6 O wner’s Guide – Redback Smart Hybrid System – v 3.8
Important safety instructions – please read
This document contains important safety instructions for products produced by Redback Technologies. Please read all the
instructions and cautionary markings on the product and on any accessories or additional equipment included in the
installation. Failure to follow these instructions could result in severe shock or possible electrocution. Always use extreme
caution to prevent accidents.
SYMBOL
DEFINITION
WARNING: LETHAL VOLTAGE INSIDE
Do not remove
inverter or battery enclosure covers unless qualified to do so or have been instructed to do so by
Redback Technologies technical
support personnel.
Do not perform any servicing other than that specified in the maintenance instructions.
Solar arrays may be energised even in low ambient light.
DANGER.
Risk of electrical shock. Proceed with caution.
WARNING: Burn Hazard.
External and internal parts may be hot. Do not remove covers during operation or touch any internal parts.
CAUTION: Hazard to Equipment
Only use components or accessories recomm
ended or sold by Redback Technologies or its authorised agents.
Handle all parts with care and follow
the instructions provided.
WARNING: Fire hazard
Do not keep combustible or flammable materials in the same room as the equipment. The Redback Smart Hy
brid
System
contains relays and switches which are not ignition protected.
Do not allow storage of any item inside the
inverter, or any items inside the battery enclosure other than
batteries.
Ensure clearance requirements are strictly enforced. Keep all v
ents clear of obstructions that can prevent proper
air flow around, or through, the unit.
DELAY.
Wait specified time e.g., 10 minutes.
This symbol indicates the information provided is important for the correct operation and or maintenance of the
equipment. Failure to follow the recommendations may result in annulment of the product warranty.
IMPORTANT
Only use the battery types recommended by Redback Technologies. Follow the battery manufacturer’s
recommendations for installation and maintenan
ce.
Insulate batteries appropriately against freezing temperatures. A discharged battery will freeze more easily than a
charged one.
Remote or automatic generator control systems: disable the starting circuit and/or disconnect the generator from
its starting battery while performing maintenance.