Reer JANUS - ACCESSORIES; Muting Junction Boxes

8540573 • 16/09/2016 • Rev.20 43
CODE
(Not flashing)
DIAGNOSIS
REMEDY
6
Short-circuit between the OSSD outputs
Carefully check the connection of terminals 2 and 3.
0
Overload of the OSSD outputs
Carefully check the connection of terminals 2 and 3
(OSSD) on the connector. If necessary, adjust load
reducing the current required to max 500 mA (2.2 F)
1
Interfering Emitter detected
(THE CODE REMAINS VISIBLE FOR
AL LEAST 30s)
Carefully locate the interfering Emitter and take action
in one of the following ways:
 Switch the position of the Emitter and Receiver
 Move the interfering Emitter to avoid this illuminating
the Receiver
 Shield the beams coming from the interfering Emitter
using opaque protections
t (flashing)
Override with pulse command expired
Reset the system