Designers who know the level 2 password can enter a new level 1 password
(alphanumerical, max 8 characters).
âž”
Operators who know this password are enabled to upload (from MOSAIC M1, MOSAIC M1S,
MOSAIC M1S COM to PC), modify or save the project.
Level 2 password
Designers authorised to work on the creation of the project must know a Level 2
PASSWORD. The first time the system is initialised the operator must use the password
"SAFEPASS" (all capital letters).
Designers who know the level 2 password can enter a new level 2 password
(alphanumerical, max 8 characters).
With the Level 2 password, the designers authorized has availabele all the functions of Level
plus the ability to downoad the project from PC to Mosaic and change the passwords
âž”
This password enables the project to be uploaded (from PC to Master), modified and saved. In
other words, it allows total control of the PC => MOSAIC system.
âž”
When a new project is UPLOADED the level 2 password could be changed.
âž”
Should you forget either of these passwords, please contact ReeR which will provide an unlock file
(when the unlock file is saved in the right directory the icon will appear on the toolbar).
When the icon is activated, the password level 1 and level 2 are restored to their original values.
This password is only given to the designer and can only be used once.
Maintenance Password (MOSAIC M1S, MOSAIC M1S COM)
MOSAIC M1S, MOSAIC M1S COM with Fw > 8.0.0: Connection (either USB or
Ethernet) adds Maintenance level.
âž”
This password carries all the privileges of level 2 with the exception that it cannot change
passwords and network parameters.
âž”
The default PSW is: "MAINTCE" which can be changed by the operator. (see "Password
protection" in the manual).
Figure 102
Password Change
To activate the PASSWORD Change use icon , after connecting with Level 2 Password.
A window appears (Figure 103) allowing the choice of the new password; insert the old and
new passwords in the appropriate fields (max 8 characters). Click OK.
At the end of the operation disconnect to restart the system.
If MCM is present the new password is also saved in it.
To Next Page
Loading...
Need help?
General
