properties, straightening is relatively easy, and there is no need to apply too much pressure on the
straightening wheel. For steel bars with irregular transverse ribs and irregular mechanical properties, such
steel bars are more difficult to straighten, and it is recommended to apply greater pressure on the
straightening wheel. After installation and debugging or special failure, the steel bars are withdrawn, and cut
them after threading and running at a slow speed for 3-4 meters before running, and then run for 3-4 meters
to observe the straightness of the steel bars. If the above 2) and 3) clauses appear The situation is adjusted
according to the adjustment prompts in each clause until the straightness of the steel bar reaches the
requirement. The adjustment method of the outer reinforcement is the same as that of the inner.
4) When the stirrups are twisted and cannot be closed during the production process, the downward
pressure of the left straightening wheel of the straightening part is not enough, and the steel is rotated. At this
time, the downward pressure of the straightening wheel needs to be re-adjusted.
Note: Each straightening wheel must be in working condition, so as to ensure the continuous work and
service life of the machine and the quality of the product.
Note: The reduction amount of the straightening mechanism should be a suitable value, otherwise it will
overload the traction servo motor current if it is too large.
Note: When the equipment is in normal operation, the safety protection door and the back door should be
closed to prevent the steel bars from popping out and hurting people; when opening or closing the safety
protection door, you should echo back and forth to prevent hurting others; when the cutter is cutting, keep
away from the cutter position , Prevent the steel bar from cutting the head and hurting people.
Fingers at risk of being crushed or cut off!
When the machine is running, it is strictly forbidden for people or other creatures to directly or indirectly touch
the moving parts of the machine and the steel bars in work. Otherwise it will cause serious injury.
The surface of the raw steel bars must be dry and free of rust, otherwise the machine will be damaged and
the safety of the operator will be affected.
Even when the equipment is in an automatic working state, it must be supervised by a trained person, and the
person in charge of the equipment should keep all the keys to prevent others from operating the equipment.
Notice:
It is strictly forbidden to touch the cutting position by hand at any time during power-on operation!
It is strictly forbidden to open the body cover at any time during power-on operation!
It is strictly forbidden to open the control cabinet while the machine is running!
To Next Page
Loading...