After setting, you must press the button, otherwise it cannot be saved in the system. Click to
confirm as the current task at last.
5.2. Preparation and inspection before use
① The equipment operator must wear a safety helmet when taking up the post.
②Plug in the aviation plug of the data line connecting the console and the host.
Note: The aviation plug of the data cable is divided into front and back. Before plugging or unplugging,
please see the direction of the notch clearly. It is strictly forbidden to plug or unplug when the power is on!
Otherwise it will cause system failure! Even burn the system! Please pay special attention to the operator!
③Turn on the power supply: Connect the main power supply terminal. It is recommended that you use a
four-core copper cable of 3×16+1×10mm2 and above, and properly ground it.
Electrical operation can only be carried out when the circuit is normal and the grounding wire is tight.
④Check whether the power supply voltage is abnormal, whether it is within the three-phase 380V±5%,
whether the wire ends of the connection wires in the electrical box fall off, especially the connection of the PE
grounding wire, and then turn on the main power switch after confirming that there is no abnormality.
⑤ Close the key power switch on the console, check whether there is an alarm display, if there is an alarm
indication, follow the fault prompt on the alarm screen to eliminate the alarm.
Note: The operating personnel must be specially trained and qualified before the operation, otherwise the
wrong operation will destroy the internal procedures and make the equipment unable to work normally.
Special attention: When it is necessary to replace a new touch screen, after the touch screen is replaced,
or when there is no original compensation data generated in any other situation, the original parameters need
to be reset. If the process parameters are not set, the event of damage to the machine will occur,
remember! ! ! (The original parameters are given in the data form by the trainer.) If the bending arm touches
the upper and lower limits during the automatic working process, it needs to return to the reference (the
bending arm returns to the original point) before it can work again.
To Next Page
Loading...