⑥ Fastening of screws in various parts
It is necessary to check the fastening of the traction wheel, meter wheel, traction spindle end cover, various
shear blades, bending bearings, forming wheel screws, and connection bolts of each box body in time.
Routine weekly maintenance
Check the tightness of the connecting bolts, and tighten them with special tools if necessary.
Check whether the cable insulation is damaged.
Whether the air filter and the pressure regulating valve are malfunctioning.
Clean up the dust of each control component.
Check the air pipe joint and air path for air leakage.
In the event of electrical failure, first check the fuse and thermal contactor, and whether the proximity
switch is damaged.
Check the protective grounding wire.
Check the wear and tear of the motor brake system.
Maintain the sanitation of the electrical cabinet and the console.
Check the tightness of the timing belts, etc., and adjust the tightness in time.
1) Monthly maintenance
Check the lubricating oil in each gear box.
Check the change of the bearing clearance of the transmission part, if there is any looseness, please adjust
it in time.
Check the oil mark to check whether the lubricating oil is in place. When the oil level is found to be low, add
CKC105 lubricating oil in time.
Since there are more oxide scales on hot-rolled steel bars during the feeding process, cleaning them every
week can reduce wear and reduce adjustment resistance.
2) Maintenance of purchased standard accessories
Reducer: Check the ventilation of the vent every week, and clean the vent in time to make it exhaust
smoothly.
Air compressor: Change No. 32 oil once a year, drain water once every shift, and check whether the belt is
loose every month.
Cylinder: The muffler will block the muffler due to environmental pollution. The muffler should be cleaned or
replaced every 3 months.
Before using the reducer, check the lubricating oil and add the specified lubricating oil. All kinds of lubricating
oil should be supplied according to the position of the oil mark and replaced strictly according to the
replacement time.
Special oil for reducer 2000 hours
Lithium-based lubricant 8000 hours
Gear oil 5000 hours
Operate strictly in accordance with the lubricating oil standard, otherwise the machine will not operate
normally, and the lubricating performance of the structure will be affected by the solidification of the
lubricating oil, which will seriously damage the various mechanisms of the equipment.
Note: The above maintenance period is the minimum requirement, and the specific time depends on the
usage of the equipment.
8. Transportation and storage
To Next Page
Loading...