Reflex GX616 - Description of Safety Precautions During Equipment Use; Operating Procedures, Methods, Precautions and Preventive Measures

5.3. Description of safety precautions during equipment use
Before use, pay attention to whether the power supply voltage is abnormal, whether it is within three-phase
380V±5%, whether the cables are damaged, whether the wire connectors fall off, whether the graphics are
edited correctly, whether the speed parameters are reasonable, whether the steel bars are disordered or
misplaced.
5.4. Operating procedures, methods, precautions and preventive measures
1) Adjustment of the amount of compression of the straightening part:
The reduction of the straightening wheels is reduced in a gradually decreasing mode, and the reduction
of the two sets of straightening wheels at the back is adjusted until the steel bars are not deformed. As shown
in the figure, the two sets of straightening wheels in the front of the two parts of pre-adjustment and
straightening are bent and deformed by compression, and the rear straightening wheels gradually reduce the
pressing amount.
2) Adjustment of up and down/inside and outside bending of steel bars:
① Press down the penultimate individually adjustable wheel on the right and raise the penultimate
individually adjustable wheel: the steel bar can be bent upwards.
② Raise the penultimate individually adjustable wheel on the right side and press down the penultimate
individually adjustable wheel: the steel bar can be bent downward.
③The pre-adjustment part mainly controls the internal and external bending of the steel bar. When the
internal and external bending of the steel bar occurs, it may be caused by insufficient compression of the
pre-adjustment part, and the pre-adjustment wheel should be increased to a suitable position.
3) Adjustment of steel bar reduction: For steel bars with uniform transverse ribs and uniform mechanical
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine