forward" if safety is confirmed, the steel bars are fed into the upper and lower traction wheels, and click the
"cylinder compression" button. The steel bars are compressed; select the processing required Set the
production quantity, click the "download" button to download the production graphics data to the PLC
controller; set the "manual/automatic" button to the middle position and press it, the bending axis will
automatically return to the original position, select "encoder valid", " Bending limit is valid", "potentiometer is
valid" and the traction and bending speed are set through the potentiometer; select "single action/continuous";
set the "manual/automatic" button to the "automatic" position, press the "start" button, at this time , The
equipment will automatically execute and complete the set production tasks.
3. Technical characteristics
3.1 The main technical parameters of the equipment
Single wire bending diameter 6–16mm
Rebar double wire bending diameter 6–12mm
Processing material Disc round, disc snail
Maximum towing speed 100 m/min
Maximum bending speed 1050 °/sec
Rib straightness error 0.02/1 meter
Total power of equipment 65KW
Average power consumption 10KW/H
Bending direction Two-way
Stirrup length accuracy ±1mm
Rib length accuracy ±5mm
Angle accuracy ±1°
Maximum bending angle ±180°
Longest stirrup side 1000mm
Shortest stirrup side 90mm
The longest length of the rib 9 meters
Working temperature -5~40 ℃
Traction control method Servo
Bend control method Servo
Loopback control method Servo
Total Weight 5.5T
To Next Page
Loading...