8.1. Precautions for hoisting and transportation
Use cranes or forklifts with a load-bearing capacity of ≥5T to hoist the equipment, and it is strictly forbidden to
fix the hoisting rope at the non-hoisting position of the equipment for hoisting;
The equipment must be fixed to the transfer vehicle with ropes or other methods during the transfer process.
Speeding and sharp turns are strictly prohibited during the transport process to avoid traffic accidents. The
vehicle must slow down when driving on potholes to avoid damage to the equipment. . During transportation,
the equipment must be covered with a rain-proof tarp or transported in a box-type vehicle to make the
equipment rain-proof and moisture-proof.
8.2. Storage conditions
When the equipment is not used for a long time, the power supply of the equipment should be cut off and the
compressed air and water in the equipment and the air compressor should be discharged; the dust and iron
filings on the equipment should be cleaned up, and all parts that need to be lubricated should be fully
lubricated , All mechanical parts should be painted with anti-rust oil; the steel bending panel should be
painted to prevent rust; the equipment should be stored in a rain-proof and moisture-proof room and covered
with a rain-proof and moisture-proof tarp.
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine
To Next Page
Loading...