provides one set of keys, and it is strictly forbidden to provide another key. During the maintenance process,
only this key can be delivered to the responsible maintenance staff for proper custody.
In order to ensure the normal operation of the equipment, the user is responsible for maintaining the
equipment and ensuring that every part of the equipment is in good working condition.
Fill in the equipment maintenance diary after equipment maintenance. This is helpful for users to master
equipment management knowledge as soon as possible. Appropriate tools should be used during equipment
maintenance and repair, which can reduce equipment damage and avoid danger. Clean up excess lubricating
oil and other oils in time to prevent soiling the steel bars and prevent fires. Clean up the iron filings and waste
materials in the workshop in time and put them together for recycling, which can also prevent injury to
workers and affect production.
7.2 Outdoor use of equipment
When the equipment is used outdoors, it should be installed in a shed with a roof and dry ground. Avoid using
it in the sun as much as possible. It is also not allowed to use it in the open air in rainy and snowy weather. It
should be protected from wind, sand and dust from blowing into the equipment and electrical control system.
Otherwise it will cause mechanical damage and malfunction.
7.3 Maintenance and maintenance of equipment
The traction part of the equipment should be regularly added or replaced with lubricating oil according to the
regulations, and the grease filling nozzle should be filled with oil every week, and each straightening shaft
should be filled with lithium-based grease every month to make the bearings sufficiently lubricated. There are
oil injection holes above the shearing mechanism and the bending mechanism, and lithium-based grease
should be injected regularly to ensure that the bearings are sufficiently lubricated. Extend the service life of
each component. In addition, the air compressor and filter should be drained regularly.
Routine maintenance per shift
Note: One shift is 8 working hours.
1 At the end or beginning of each work shift, perform a general cleaning work to remove oxide scale and
debris.
2 Check the integrity of the movable blade and the static blade at any time, whether the fixing nut of the
traction wheel and the compression wheel is loose, and check the tightness of the traction part of the
conduit, otherwise the lower traction wheel will be broken, and the iron filings will splash out.
3 When the temperature is lower than 3℃, the water must be discharged at the end of each shift, otherwise
the entire pneumatic system will not work normally due to the freezing of the water.
4 When the temperature is lower than 3℃, it is required to use cotton yarn to absorb the water vapor in the
muffler at the end of each shift, otherwise it will cause the cylinder to move slowly or fail to work.
5 Lubrication.
NO
Lubrication part Lubricant Refueling time Remark
1 Forming wheel Lithium-based grease (10g) once a week Grease gun injection
2 Bending bearing Lithium-based grease (10g) once a week Grease gun injection
3
Shear rocker Lithium-based grease (10g) once a week Grease gun injection
4
Curved components Lithium-based grease (10g) once a week Grease gun injection
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine
To Next Page
Loading...