G) Create a new graphic file
When the button in the running screen of the touch screen is pressed, the current graphics
parameters will be cleared, and the following new graphics screen will be entered:
illustrate:
The user can set according to the length dimension and bending direction of each section of the required
product length, angle, type, Length compensation,
angle compensation
If you want to do slab reinforcement, you must choose the return arrow behind the longest side, and
the first angle must be a negative number!
As shown below:
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine
To Next Page
Loading...