INT-14
Yacht Plate
At the helm area on Regal boats 26’ and longer is located a yacht plate
as shown below. This plate represents manufacturers who participate
in the National Marine Manufacturer’s Association yacht certifi cation
program. This program goes beyond the minimum USCG standards
to ensure adherence to the American Boat & Yacht Council (ABYC)
standards. NMMA approved inspectors are utilized to verify compliance
to these standards.
Note the yacht plate information below:
• The operator of the craft must read and understand the plate
information before operating the vessel.
• The boat operator is responsible for the vessel and the safety
of his passengers.
TYPICAL EXAMPLE SHOWN
Safe Loading
The vessel operator is responsible for his passengers. Follow the seat
position illustration in the technical section of this manual. Explain to
all passengers before the outing the importance of keeping the overall
load balanced. Also, emphasize that passengers must remain seated while
the vessel is in motion for the safety of the other passengers. Make sure
that all passengers are positioned in their seats to afford clear visibility
for the operator in all directions. Appoint passengers as “lookouts” for
the operator and to signal before a dangerous situation develops.
To Next Page
Loading...
