7-48
CHAPTER 7
Remote Control
On selected propulsion packages check the helm control box and
the cable attachment at the engine for tightness and shifting without
binding. This applies to engines with standard remote controls only.
Shift and throttle controls at both the engine and helm areas must be
checked on a periodic basis. At the engine end, make sure all control
cable hardware is tight and control cable brackets are secure. An
application of silicone spray on the cable ends periodically will keep
control cables working freely and fi ghts corrosion. At the helm end
check to make sure the control box hardware is tightly secured. Contact
a marine professional or Regal dealer for further assistance.
Note: Volvo joystick type propulsion and Merc DTS units do not use
an actual control cable in the system. Shifting is accomplished through
electronic software. See appropriate engine operation manual for further
information.
To Next Page
Loading...
