CHAPTER 6
6-66
TO PREVENT VESSEL FROM SINKING,
INSTALL DRAIN PLUG!
Drain Plug
Your vessel is equipped with a hull
drain plug. It is located at the aft
keel area mounted on the transom.
Make sure it is tightly installed before
launching. Tighten with a wrench but
do not overtighten it. Do not use your
fi ngers alone. Before dry storing it
is recommended to remove the drain
plug to help eliminate any bilge water accumulation. When the water
stream is diminished, remove any foreign objects stuck in the drain hole.
Remove the drain plug if dry storing the boat for extended periods
especially in colder climates. Place the plug in a bag and attach to the
steering wheel.
TIGHTEN-CLOCKWISE
TYPICAL DRAIN PLUG
To Next Page
Loading...
