Equipment Operation
6-115
The system uses a combination of suction and water fl ow from the
fresh water tank to clear the head of waste.
The system components including the hose are formulated for the
transfer of sanitary waste only. Do not allow the following items in
the system: Strong acid or caustics such as drain openers, petroleum
solvents or fuels, alcohol based products such as antifreeze and pine
oil products along with sanitary napkins and baby diapers.
To operate the head;
1. Activate the pressurized fresh water system switch found on the
head 12 volt panel by pulling out on the device. The fresh water tank
is the water source for the system. See the illustration on the next
page.
2. Next, activate the switch located at the head wall to fl ush liquid
or solid waste. The system requires more water for solid over liquid
waste. Note the switch control below.
3. Adding water to the toilet is recommended before fl ushing solid
waste. Simply press the
“add water” button and
hold for 1 second. Ap-
proximately 17 ounces of
water is added to the bowl.
There are system electron-
ics that prevent overfi ll of
the bowl.
The fl ush button is recom-
mended for fl ushing liquid
waste since it saves water and fi lls up the holding tank at a slower rate.
To empty the bowl without adding water or starting a fl ush sequence,
push and hold both buttons together until the bowl contents are dis-
charged. Pushing either button at this point retuns toilet fl ushing to
normal operation.
TYPICAL HEAD WALL SWITCH
To Next Page
Loading...
